Tpm 2.0 Location; Hpe Trusted Platform Module 2.0 Guidelines - HPE ProLiant BL460c Gen10 User Manual

IMPORTANT: In UEFI Boot Mode, the HPE TPM 2.0 Gen10 Kit can be configured to operate as
TPM 2.0 (default) or TPM 1.2 on a supported server blade. In Legacy Boot Mode, the configuration
can be changed between TPM 1.2 and TPM 2.0, but only TPM 1.2 operation is supported.

TPM 2.0 location

The TPM 2.0 is located on the system board near the front of the server blade.

HPE Trusted Platform Module 2.0 Guidelines

CAUTION: Always observe the guidelines in this document. Failure to follow these guidelines can
cause hardware damage or halt data access.
Hewlett Packard Enterprise SPECIAL REMINDER: Before enabling TPM functionality on this system,
you must ensure that your intended use of TPM complies with relevant local laws, regulations and
policies, and approvals or licenses must be obtained if applicable.
For any compliance issues arising from your operation/usage of TPM which violates the above mentioned
requirement, you shall bear all the liabilities wholly and solely. Hewlett Packard Enterprise will not be
responsible for any related liabilities.
When installing or replacing a TPM, observe the following guidelines:
• Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
• When installing or replacing hardware, Hewlett Packard Enterprise service providers cannot enable
the TPM or the encryption technology. For security reasons, only the customer can enable these
features.
• When returning a system board for service replacement, do not remove the TPM from the system
board. When requested, Hewlett Packard Enterprise Service provides a TPM with the spare system
board.
Hardware options installation 69