Setup; Overview; Server Blade Warnings And Cautions; Installing An Hpe Bladesystem C-Class Enclosure - HPE ProLiant BL460c Gen10 User Manual

Setup

Overview

Installation of a server blade requires the following steps.
Procedure
1. Install and configure a BladeSystem c-Class enclosure.
2. Install any server blade options.
3. Install interconnect modules in the enclosure.
4. Connect the interconnect modules to the network.
5. Install a server blade.
6. Complete the server blade configuration.

Server blade warnings and cautions

WARNING: To reduce the risk of shock or injury from high-current electrical energy, do not remove
the server blade access panel and then install the server blade into the enclosure.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: Do not operate the server blade with the access panel removed. Operating the server
blade in this manner results in improper airflow and improper cooling that can lead to thermal
damage.
CAUTION: When performing non-hot-plug operations, you must power down the server blade
and/or the system. However, it might be necessary to leave the server blade powered up when
performing other operations, such as hot-plug installations or troubleshooting.
WARNING: To reduce the risk of fire or burns after removing the energy pack:
• Do not disassemble, crush, or puncture the energy pack.
• Do not short external contacts.
• Do not dispose of the energy pack in fire or water.
After power is disconnected, battery voltage might still be present for 1s to 160s.

Installing an HPE BladeSystem c-Class enclosure

Before performing any server blade-specific procedures, install an HPE BladeSystem c-Class enclosure.
The most current documentation for the server blade and other BladeSystem components is available on
the Hewlett Packard Enterprise website.
Setup 39