Starting A Recording Using The Vlp2 - L3 Mobile-Vision Flashback3 User Manual




Starting a Recording Using
the VLP2
To start a recording, slide the VLX switch down. The unit will vibrate once, indi-
cating that you have successfully initiated a recording. To stop a VLX initiated
recording, press
twice, indicating that you have successfully ended the recording.
HINT: If you receive any audio feedback after activating the microphone, use the
button on your Flashback monitor to decrease the volume slightly.
WARNING: If you feel two short vibrations approximately 10 seconds after you in-
itiate a recording, it indicates that the recording has stopped. This typically occurs
because you left the DVR door open.
P a g e 16
Always maintain a strong battery charge. For more information, see "VLP2
Battery Considerations" on the next page.
Configure your VLP2 as a record trigger on the Flashback. If you are using the
Fleet Management feature, see "Changing the Triggers for a Flashback DVR that is
Not Assigned to a DVR Group" or "Changing the Triggers for a Flashback DVR
Group" in the DVRs chapter of your DES Administrator's Guide. If you are not
using the Fleet Management feature, see "Selecting & Configuring Record
Triggers" on page 90.
Use the VLP2 with the lapel mic. Although the VLP2
comes with an internal mic, it is designed only as a
backup mic in the event that the lapel mic fails. Whenever
possible, use the lapel mic as your primary microphone.
If you use the internal mic as your primary microphone,
you may encounter audio interference due to wind
and road noises that are more easily picked up
when a mic is connected to your waist vs.
your chest.
To initiate a recording session,
slide this switch down.
from the Flashback monitor or DVR. The unit will vibrate
VLP2 Wireless Microphone
Flashback3 & Flashback HD User's Guide
L3 Mobile-Vision  6.23.2017
Peripherals