Entering/Changing The Wireless Gateway Ip - L3 Mobile-Vision Flashback3 User Manual

9 To enter/change the first segment of the IP address, proceed to the next step.
Otherwise use the
10 If the current value of this IP segment is 0, proceed to the next step.
– OR –
If the current value of this IP segment is 1 – 255, use the
the numeric display higher or lower, respectively. Next, skip to step 12.
11 Press
number displays. (If you overshoot the number, press
12 Use the
13 Repeat steps 10 – 12 until all four segments of the IP address are entered/updated.
14 Press

Entering/Changing the Wireless Gateway IP

This section describes how to enter or change the gateway address for the DVR's
wireless network interface card (NIC). This value is usually set to the IP of the
storage server.
NOTE: If you want your DHCP server to automatically provide the wireless IP
addresses to this DVR, do not enter this field. Instead, turn the Wireless DHCP
option on, as described in "Turning the Wireless DHCP Option On/Off" on page 155.
1 Make sure the door to your DVR is open and Auto mode is off. (If necessary, press
the
2 Press
P a g e 152
button to advance to the first segment you wish to change.
. The number 255 displays. Keep pressing the
button to advance to the next segment you wish to enter/change.
four times to save your changes and exit this option.
button until the light turns off.)
. The Main Menu displays.
DVR Settings
Entering/Changing the Wireless Options
or buttons to move
button until the desired
to back up.)
Flashback3 & Flashback HD User's Guide
L3 Mobile-Vision  6.23.2017