Entering/Changing The Wireless Options - L3 Mobile-Vision Flashback3 User Manual

8 Press
9 Press
10 Press

Entering/Changing the Wireless Options

This section describes how to enter or change the wireless options that enable your
DVR to communicate with your agency's access points (for a definition, see
Glossary). Typically, you only need to enter these options if 1) your Flashback is
installed in a vehicle, or 2) your Flashback is installed in an interview room and you
are using the Vehicle Viewer or Vehicle Viewer Live application. If your DVR is
installed in an interview room and you are not using Vehicle Viewer or Vehicle
Viewer Live, see "Entering/Changing the Ethernet Options" on page 158 instead.
These procedures should be performed under the guidance of your agency's IT staff
or an L3 Mobile-Vision Support professional.
For specific instructions, see:




P a g e 146
to select the WLAN display field.
to toggle the field value to ON or OFF.
four times to save your changes and exit this option.
Entering/Changing the Wireless IP, next page
Entering/Changing the Wireless IP Mask, page 149
Entering/Changing the Wireless Gateway IP, page 152
Turning the Wireless DHCP Option On/Off, page 155.
DVR Settings
Entering/Changing the Wireless Options
Flashback3 & Flashback HD User's Guide
L3 Mobile-Vision  6.23.2017