Checks And Inspections - Iveco VECTOR Series Technical And Repair Manual

VECTOR 8 ENGINES

Checks and inspections

NOTE The following checking inspections must be carried
out after the engine assembly on the vehicle .
Start the engine and leave it running just above the
idling speed, wait until the coolant reaches the
temperature necessary to open the thermostat and
then check:
- that there are no water leaks from the connecting
sleeves of engine cooling circuit pipes and cab internal
heating pipes, tighten the clamping collars if required;
- the connection between the low pressure fuel pipes and
the relevant connectors;
- that there are no oil leaks between the cover and the
cylinder head, between oil sump and engine block,
between heat exchanger oil filter and the relevant
housings and between the different pipes in the
lubricating circuit;
- that there are no fuel leaks from the fuel pipes;
- that there are no air leaks from pneumatic pipes (if
fitted);
Carefully check and bleed the engine cooling equipment by
repeated draining operations.
Print P2D32V001E
SECTION 3 - INDUSTRIAL APPLICATION
41
Base - April 2006