24
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
Figure 43
- Rotate the crankshaft fowards until a lifting height of 5.48
mm is reached.
- The camshaft is timed if the reference mark made
previously on the crankshaft is aligned with the reference
on the cylinder block/crankcase.
Figure 44
If the above condition is not achieved, the camshaft should be
adjusted using the openings in the toothed wheel.
See timing diagrams overleaf.
Base - April 2006
Figure 45
82243
Fit the flywheel (2) taking care to ensure that the reference
markt (1) is aligned with the position of the camshaft rpm
sensor (see timing diagrams on the pages that follow).
Tighten the bolts (3) to the recommended torque.
82244
VECTOR 8 ENGINES
113063
Print P2D32V001E