VECTOR 8 ENGINES
CHANGING BLOW-BY FILTER
The blow-by filter is positioned, by means of a support, to
the gearbox supporting bracket in front of the passenger cab
water/heating water heat exchanger.
The blow-by filters can only be replaced by taking the unit
apart completely and disassembling the same at the bench.
Improper waste disposal is a threat for the
environment. Potentially hazardous waste used on
IVECO vehicles includes lubricants, fuels, coolants,
filters and batteries.
—
Use watertight containers when draining off
fluids. Never use containers for foodstuffs or
beverages that can lead people to drink from
them.
—
Never throw waste on the ground, on tips or
in water courses.
—
Obtain information on the appropriate ways
of recycling or disposing of waste from the
local authorities or collection centres.
Figure 26
- Disconnect the inlet pipe (3) to the filter and the
condensed oil drain pipe (2) to the sump.
- Loosen the straps that retain the sleeves (4) for vapour
escape towards the outlets.
- Unscrew the screws (5) securing the filter on its bracket.
Support the blow-by filter to prevent sudden
NOTE
disconnection.
Print P2D32V001E
SECTION 3 - INDUSTRIAL APPLICATION
Figure 27
- Loosen screws (5) on both sides, then separate the two
covers (4) from the filter (1) body.
- Take out the two filters (2), then replace them.
- Re-assemble the various parts after washing the body and
covers with a suitable detergent.
NOTE
Replace the gasket (3).
- After the filter has been fitted, place it into its own
housing on the support secured to the gearbox
supporting bracket.
95
Base - April 2006