Iveco VECTOR Series Technical And Repair Manual page 163

VECTOR 8 ENGINES
Figure 10
- Always change the coolant seals (3, 4 and 5).
Fit the top brass ring (2) onto the cylinder liner (1).
Lubricate its bottom portion and fit it in the cylinder
assembly with the plate (5) of tool 99360799 (6).
Figure 11
- Using a dial gauge (1), check that the protrusion of the
cylinder liner (2) from the mating surface of the cylinder
head is from 0.025 to 0.095 mm.
Figure 12
- Change the seals (5) of the bushing (3) for the left—hand
main oilway. The bushing (3) is removed from the cylinder
assembly with a percussion extractor (1) and a suitable
part (2). Use an appropriate drift to fit the bushing.
Print P2D32V001E
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
Figure 13
- Change the seals (5) of the bushing (3) for the right—hand
82720
main oilway. The bushing (3) is removed from the cylinder
assembly with a percussion extractor 99340205 (1) and a
suitable part (2). Use an appropriate drift to fit the bushing.
Figure 14
16799
- If changing the bushing (1) for the coolant duct, use general
tools for removal; use an appropriate drift (2) for assembly.
16803
13
16804
16805
Base - April 2006