Iveco VECTOR Series Technical And Repair Manual page 72

20
SECTION 3 - INDUSTRIAL APPLICATION
Figure 31
1
- Fit tool 99368502 (1) and place the fixed spanner (2) as
shown in the diagram to prevent the rotation of the
flywheel during the dismantling of the pulley and the
damper flywheel on one side and the actual flywheel on
the other.
Figure 32
4
3
Figure 33
5
4
3
2
1
- Undo the M8 bolts (1) and remove the cover (2) for the
gear casing. Remove the gasket (3).
- Remove the duct (12).
- Unscrew the screw (4), remove the shaft (5) and the
gear (6) with the bearing (7).
Base - April 2006
2
103191
1
2
103192
1 2
7 8
6
1
- At the front, undo the 8 botls (1) and remove the pulley
(2), the damper flywheel (3) and the counter-weight (4).
Figure 34
- Remove the oil seal (1) using the tool 99368514 (2).
1 0
9
13
- Rotate the engine and remove the oil sump.
- Remove the engine lubricating oil pump with the suction
cup.
- Undo the bolt (10) securing the gear casing (11) to the
cylinder block/crankcase; after having removed the gear
casing, undo the bolt (9) and remove the spacers (8) and
(13) complete with O-rings.
VECTOR 8 ENGINES
82223
11
103193
Print P2D32V001E