Iveco VECTOR Series Technical And Repair Manual page 70

18
SECTION 3 - INDUSTRIAL APPLICATION
Figure 23
- Unscrew the fixing screws and remove the water outlet
pipes (1) from the heads.
- Remove the thermostat casing (5).
NOTE Separate the screws appropriately, marking their
placement to facilitate assembly.
- Then remove the engine water/oil cooler (2),
unscrewing the M10 x 40 mm screws (three on both
sides).
- Remove the diesel supply pipe from the high—pressure
pump (the coupling has been removed together with the
ADEM III control unit support).
- Remove the diesel recovery piping.
- Remove the intake manifolds (3), remove the gaskets
and remove the high pressure pump (4) from the
flywheel casing complete with gear.
NOTE Separate the screws appropriately, marking their
placement to facilitate assembly.
Base - April 2006
Figure 24
- Remove the driving gear with the aid of tools 99368516
(1), 99368517 (2) that permit unscrewing the M24 x 1.5
nut (3).
Figure 25
- Unscrew the screws (1) and remove the exhaust
manifolds (2) on both sides comprehensive of seals.
VECTOR 8 ENGINES
103190
82214
82215
Print P2D32V001E