Fitting - Iveco VECTOR Series Technical And Repair Manual

VECTOR 8 ENGINES
Figure 30
- After removing the pump, separate the components
from (1) to (7).
Figure 31
- Put the pump on the bench and, using the right pliers,
remove the snap ring (1).
- Remove the drive disc (2).
Figure 32
- Put in a vice and undo the central screw so as to be able
to remove the disc (1).
Print P2D32V001E
SECTION 3 - INDUSTRIAL APPLICATION
Figure 33
- Turn the pump and undo the three screws (7, Figure 30)
fixing the cover (6, Figure 30), complete with seal (1).

Fitting

- At the assembly stage, after changing the damaged parts,
assemble all the parts on the bench to complete the
pump.
Change the seal on the cover. If the pump is not
NOTE
changed, wash to remove any incrustation.
Figure 34
- Fitting the complete pump on the gearbox must include
engaging the teeth (1) on the gear (2) on the drive disc.
- then screw the nuts onto the stud bolts on the gearbox.
- tightening torque 33 ÷ 40 Nm.
- then connect the water pipes.
97
Base - April 2006