Iveco VECTOR Series Technical And Repair Manual page 64

12
SECTION 3 - INDUSTRIAL APPLICATION
Figure 3
- Remove the engine wiring: disconnect the wiring from
coolant temperature sensor (1), sensors (2 and 14), XJ2
connector from ADEM III (4), atmospheric pressure
sensor (5), fuel temperature sensor (6), electro injector
(7), engine speed sensor (8), timing system speed sensor
(9), common rail fuel pressure sensor (10), common rail
high pressure control solenoid valve (11), turbo—blower
air temperature sensor (12) and air pressure sensor in
the intercooler (13).
NOTE The oil filter blockage sensor (3) and the alternator
(15) are not connected to the engine lead.
Base - April 2006
Figure 4
2
5
- Remove the diesel filter (1) using tool 99360091.
NOTE On the DRAGON and GRIFFON applications, the
fuel filters are fitted in a remote position.
- Remove the ADEM III engine management control unit
(2) from its mounting undoing the bolts for the flexible
mountings (3).
- Remove the atmospheric pressure sensor (4) from the
support.
- If present on the application, remove the flexible belt (16)
and the air conditioning compressor (17).
- Completely undo the screw (5) and release the belt (6).
- Remove the alternator complete with bracket.
- Remove the control unit support complete with diesel
filter mounting.
VECTOR 8 ENGINES
112865
4
1
3
6
103227
Print P2D32V001E