Iveco VECTOR Series Technical And Repair Manual page 71

VECTOR 8 ENGINES
Figure 26
- From the front side disassemble the engine oil filter
supports (1) including the oil temperature transmitters
(2), the pressure sensor (5), the seal (4) and the filter clog
sensor (3).
- Remove the remaining diesel pipe from the LPP to the
filter mounting (the two components have already been
removed previously)
NOTE If necessary, replace the worn parts. Always change
the seals in the assembly phase.
Figure 27
- Remove the electro—injectors. Using the wrench (2),
unscrew the screw (1) of the fixing bracket.
Figure 28
- Fit the tool 99368505 (1) and the wrench for extracting
the electro—injector.
Print P2D32V001E
Always change the O—ring in the assembly phase.
NOTE
Lubricate the O-rings with vaseline before
installating
Figure 29
82216
- Unscrew the fixing screws (1) and remove the tappet
cover (2). Repeat this operation for all the covers.
Note down the position of the tappet covers in
NOTE
relation to the heads so as to fit them in the
positions they had with the first assembly.
Figure 30
82217
- Remove the rocker arms (2) from the support (1), taking
out the circlips and seals on both sides of the support.
Extract the rods (3) from their seat on the heads and the
jumpers (4).
- Unscrew the fixing screws (7) and remove the head (6).
Remove the cases (5) protecting the valves.
The screws (7) fixing the head on the crankcase
NOTE
have different sizes:
M15x170
M15x185
82218
Mark them so as to facilitate the assembly phase.
SECTION 3 - INDUSTRIAL APPLICATION
19
82219
82220
Base - April 2006