Iveco VECTOR Series Technical And Repair Manual page 100

48
SECTION 3 - INDUSTRIAL APPLICATION
Engine speed/timing sensor on camshaft
This is an inductive type sensor and is positioned on the distribution shaft (reference 9, Figure 1).
It generates signals that are obtained by means of the magnetic flow lines that close up through the holes on the gears that are
keyed on the distribution shaft.. The signal that is generated and sent to the electronic unit that can calculate the injection moment.
The sensor must be assembled by tightening it to torque 28 ± 7 Nm.
Figure 5
Engine speed/timing sensor on crankshaft
This is an inductive type sensor and it is positioned on the engine flywheel (reference 8, Figure 1).
It generates signals obtained by means of the magnetic flow lines that close up through the holes that are made in the flywheel.
The electronic unit uses this signal in order to detect different engine r.p.m. states.
Figure 6
Base - April 2006
Tecnical view
Tecnical view
VECTOR 8 ENGINES
Print P2D32V001E