VECTOR 8 ENGINES
Figure 35
- From the inside of the flywheel box prevent flywheel
rotation by using rotation tool 99368502 (1) and fixed
wrench (2). Then loosen screws (3).
Figure 36
- Fit the supporting tool 99368533 (1) for disassembling
and assembling the flywheel. Go ahead and unscrew the
flywheel fixing screws. Remove washer and engine
flywheel assembly.
Print P2D32V001E
Figure 37
103194
- Fit the tool 99368513 (1) and extract the rear oil seal (2).
Figure 38
103219
- Unscrew the screws (1), (2) and (3) after suitably slinging
the flywheel cover casing (4). Detach the flywheel cover
casing from the crankcase.
NOTE Mark the position of the screws (1), (2)
Screws (1): M12x35 mm 6 bolts tot.
Screws (2): M14x90 mm 12 bolts tot.
SECTION 3 - INDUSTRIAL APPLICATION
21
82228
103195
Base - April 2006