Iveco VECTOR Series Technical And Repair Manual page 92

40
SECTION 3 - INDUSTRIAL APPLICATION
Figure 85
- Fit the oil pipes (1) and (2) for lubricating the turbines.
Tightening torques:
screw fixing bottom pipes draining oil from the
turbo—blower to the oil sump — M8x1.25 = 22—27 Nm.
Screw fixing pipes delivering oil to the turbo—blower —
M8x1.25 = 22—27 Nm.
- Fit the engine support.
Screw fixing rear engine support (M16x2)
1st step Torque: 95÷105 Nm
2nd step Angle: 85˚-90˚
Guard torque: 310÷420 Nm
Screw fixing front engine support (M14x2)
1st step Torque: 65÷75 Nm
2nd step Angle: 60˚-65˚
Guard torque: 190÷270 Nm
Base - April 2006
Figure 86
2
5
- Fit the control unit support (3) on the engine (M8x1.25
bolts to be tightened to a torque of 22-27Nm) complete
with atmospheric pressure sensor (5) and diesel filter
mounting.
103228
- If present on the application, fit the air conditioning
compressor (17, Figure 3) and the flexible belt (16, Figure
3).
- Fit the alternator complete with mounting bracket and
tension the bolt (6) tightening the bolt (5).
- Fit the ADEM III control unit (2) on the support with the
flexible mounts (3) (M8x1.25 screws to tighten to a
torque of 22 — 27 Nm).
- Fit the engine electric cable connecting the control unit
to the various sensors and services.
Suitably secure the electric cable on the engine with the
clamps.
- Fit the oil filters and the diesel filter (if present).
NOTE The filters must be tightened by hand after lightly
lubricating the seals.
Tighten for another 3/4 turn with 99368539 tool.
- Fit the protective grilles (if present).
- Affix the plate warning the engine has no lubricating oil.
VECTOR 8 ENGINES
4
1
3
6
103227
Print P2D32V001E