Iveco VECTOR Series Technical And Repair Manual page 67

VECTOR 8 ENGINES
For G-DRIVE, GRIFFON and SPRINKLER applications
Figure 12
- Unscrew the three screws (1) fixing the support to the
gearbox and remove the the low—pressure supply pump
(2).
- On the bench, go ahead and remove the support (3) and
separate the low—pressure supply pump (2); in addition,
remove the coupling drive (4).
For DRAGON applications
Figure 13
- Disconnect the coolant connecting pipes (1).
It is advisable to plug both the pipes and the ports on
NOTE
the compressor that has to be shipped for overhaul.
- Unscrew the fixing screws of brakets (13, Figure 15)
- Unscrew the screws (2, Figure 13) fixing the compressor
on the spacer.
Figure 14
- Take the compressor to the workbench and separate
the low-pressure pump (if not previously removed ).
Print P2D32V001E
NOTE Recover the universal joint (1), checking its state of
wear.
- After firmly securing the compressor in a vice, remove
the gear (2) by unscrewing the nut (3) and using a specific
extractor. In addition, remove the fittings (4) and (5).
Figure 15
103475
- Unscrew the screw (13) that fixing the LPP (8) to air
compressor.
- Divide the LPP (8) from air compressor and recover
coupling drive (9) and O-ring (10).
For all applications
Figure 16
89698
- Check the state of wear of the coupling drive and its
coupling with the low—pressure pump spindle.
Figure 17
81969
- Remove the starter motor by unscrewing the three nuts
(1).
SECTION 3 - INDUSTRIAL APPLICATION
15
89697
83490
82205
Base - April 2006