Furuno FV-110GX Operator's Manual page 94

Configuration with the web interface
The following figure shows an example of a statistics report.
Remote syslog
You can set up the antenna to send each syslog message to a syslog server to advise the
system administrator of the current status of the antenna.
To set up sending syslog messages to a syslog server, do as follows:
1. Select SETTINGS > Reporting.
2. In the section Remote syslog select On to enable remote syslog (default: Off).
3. Enter the IP address of the syslog server to which the syslog messages will be sent.
4. Click Apply.
SNMP traps
SNMP traps, or notifications, are network packets which advise the system administrator
about significant events in the antenna, e.g. alarms and system error messages. They are
generated by the antenna and can be sent automatically to an SNMP trap
receiver/manager).
To set up reporting SNMP traps to an SNMP server, do as follows:
1. Select SETTINGS > Reporting.
2. In the section SNMP traps select On to enable sending of SNMP traps (default: Off).
3. Enter the IP address of the SNMP trap receiver/manager to which the SNMP traps
will be sent.
5-30
Figure 5-21: Statistics report (example, MS Excel 2007)