Furuno FV-110GX Operator's Manual page 33

CAUTION! Avoid sharp edges where the flange is in
direct contact with the radome. Round all edges as much as
possible to avoid damaging the surface of the radome.
3. Allow sufficient space so the nut is free of the welded seam and there is room for tools
(min. 50 mm).
Allow sufficient space so the
nut is free of the welded seam
and there is room for tools
(min. 50 mm).
Clearance hole
for M12 bolts
Figure 2-8: ADU mast flange, distance to the welded seam
4. Use the dimensions in the following figure to prepare the mast flange for mounting of
the ADU.
Current antenna
50
247.5
ø350
248
R326
Figure 2-9: ADU, bottom view
Site preparation
72.5
247.5
N-Connector
164.5
New antenna
2-9