Furuno FV-110GX Operator's Manual page 147

Error
Unit
code (ID)
0A040-0 Antenna WARNING VIM cable attn
0A043-0 Antenna WARNING LNB voltage
0A044-0 Antenna WARNING LNB voltage
0A047-0 Antenna ERROR
0A048-0 Antenna WARNING VIM tuner lock
0A049-0 Antenna WARNING Azi encoder slip A slip of the azimuth encoder has been
0A04A-0 Antenna WARNING Xel encoder slip A slip of the cross-elevation encoder has been
0A04B-0 Antenna WARNING Ele encoder slip A slip of the elevation encoder has been
0A04D-0 Antenna WARNING GNSS position
0A04E-0 Antenna WARNING GNSS velocity
0A04F-0 Antenna WARNING Heading data
0A050-0 Antenna ERROR
0A051-0 Antenna ERROR
0A052-0 Antenna ERROR
Severity Description
low
high
VIM PLL lock
Azi DDM
communication
Xel DDM
communication
Ele DDM
communication
Table B-1: ADU event messages (Continued)
Explanation
The output power cannot be controlled
correctly. Check the Tx chain.
The voltage for the LNB is too low probably
caused by a malfunctioning VIM/TIM or LNB.
The voltage for the LNB is too high probably
caused by a malfunctioning VIM/TIM.
The PLL of the VIM/TIM is out of lock. Check
the 10 MHz reference signal.
The PLL of the second receiver (DVB) is out
of lock. Check the 10 MHz reference signal.
detected. If this event is not resolved by itself
after some time, check the belt and encoder of
the azimuth axis.
detected. If this event is not resolved by itself
after some time, check the belt and encoder of
the crosselevation axis.
detected. If this event is not resolved by itself
after some time, check the belt and encoder of
the elevation axis.
No position available from the GNSS device or
position too old.
No velocity available from the GNSS device.
Heading information is missing in the antenna.
Communication error between PCM and
azimuth DDM. Check SUB-D connectors and
cables.
Communication error between PCM and cross-
elevation DDM. Check SUB-D connectors and
cables.
Communication error between PCM and
elevation DDM. Check SUB-D connectors and
cables.
List of ADU events
B-5