Table of Contents
Advertisement
Icon
To navigate the web interface
• To expand a menu, click the menu in the navigation pane.
• To access status and settings, click the relevant subject in the navigation pane or click
the relevant icon in the icon bar. The status or settings are displayed in the contents
section.
• To get an overview over the submenus available, click SITE MAP in the navigation
pane. Click on items in the site map to go directly to the relevant location.
You can give access to some configuration settings for users
Note
that are not administrators. For information see To set up user
permissions for guest login on page 5-33.
To connect a PC
To connect a PC to the ACU do as follows:
1. Connect a PC to LAN interface 3 (Service port, standard Ethernet) of the ACU or to
the front LAN connector of the ACU.
If you want to use another LAN port to access the web interface you must configure it
according to your network requirements. See To configure the LAN network on
page 5-23 for more information.
2. Open your Internet browser and enter the IP address of the ACU (Default IP address:
http://192.168.0.1).
Status field in the icon bar
The top bar shows the current status of the antenna.
• Antenna initializing
• Antenna SW upload
• Antenna POST error
• XIM data error
• Unrecoverable XIM data error
• System upgrade
• Antenna POST pending
• Antenna POST
• Safe Mode (error, followed by an error description)
An event is active. Click the icon to see a list of active events.
For explanations of the event messages, see Event messages –
overview on page B-1. Note that this icon will remain in the
icon bar as long as the event is active.
Table 5-5: Web interface: Event icon
Configuration with the web interface
Explanation
:
5-17
Advertisement
Table of Contents
