Furuno FV-110GX Operator's Manual page 148

List of ADU events
Error
Unit
code (ID)
0A053-0 Antenna ERROR
0A054-0 Antenna ERROR
0A055-0 Antenna WARNING Azi DDM
0A056-0 Antenna WARNING Xel DDM
0A057-0 Antenna WARNING Ele DDM
0A058-0 Antenna WARNING PMM warning
0A059-0 Antenna WARNING Azi cal. limits
0A05A-0 Antenna WARNING Xel cal. limits
B-6
Severity Description
ISM
communication
PMM
communication
warning
warning
warning
Table B-1: ADU event messages (Continued)
Explanation
Communication error between PCM and ISM.
Check SUB-D connectors and cables.
Communication error between PCM and
PMM. Check SUB-D connectors and cables.
The azimuth motor controller has temporarily
observed an unusual situation with regards to
temperature, voltage, current or velocity. No
user interaction required.
The cross-elevation motor controller has
temporarily observed an unusual situation with
regards to temperature, voltage, current or
velocity. No user interaction required.
The elevation motor controller has temporarily
observed an unusual situation with regards to
temperature, voltage, current or velocity. No
user interaction required.
The polarisation motor controller has
temporarily observed an unusual situation with
regards to temperature, voltage, current or
velocity. No user interaction required.
Azimuth axis calibration result check limits
exceeded. Pointing performance may be
degraded. Info:
0x00000040: End stop detected before
expected limit
0x00000100: Zero width is low
0x00000200: Zero width is high
0x00000400: Zero slack is high
0x00001000: Friction average is high
0x00002000: Friction peak is high
0x00004000: Friction asymmetry is high
Zero width low/high: Zero reference module
placement may be incorrect.
Zero slack high: Mechanical slack may be too
high. Friction average/peak high: Mechanical
friction is higher than expected.
Friction asymmetry high: Mechanical
imbalance may be too high.
Cross-elevation axis calibration result check
limits exceeded. Pointing performance may be
degraded. Info: See 0A059-0.