Furuno FV-110GX Operator's Manual page 152

List of ACU events
Error
ACU
code Severity
PCB
(ID)
08101-0 ADM ERROR
08102-0 ADM ERROR
08103-0 ADM ERROR
08104-0 ADM ERROR
08107-0 ADM ERROR
08108-0 ADM ERROR
08109-0 ADM ERROR
0810A-0 ADM ERROR
0810B-0 ADM ERROR
0810C-0 ADM ERROR
0810E-0 ADM ERROR
08800-0 ADM ERROR
B-10
Description
PSM high voltage
(48 V)
PSM 5 V power
ADM hotswap
Antenna
communication
ADM FPGA load
TX Power Detector
calibration
Antenna XIM data
ADM production
data
Antenna software
version
File system
integrity
RF calibration
Internal power
supply
Table B-2: ACU event messages (Continued)
Explanation
The ADM measures a different antenna voltage
than expected. Check for short circuit of the
antenna coax connector. If the problem is not
solved by a restart, and the PSM is not reporting
any errors, the ADM is probably defective.
Internal voltage supply error of the ADM.
The ACU is not able to supply the correct
voltage to the antenna. Check for short circuits in
coax cable and the antenna
The ACU cannot communicate with the antenna.
Check cable and antenna.
The ADM FPGA cannot be initialised and
loaded.
The power detector calibration is not valid.
There is a mismatch with the antenna
configuration data. Either the PCM or the VIM
in the antenna are malfunctioning or one of them
has been replaced. In the latter case, select which
is the original device in the web interface and
restart the system.
Production data has been corrupted.
An error has occurred during upload of software
to the antenna, the antenna software version is
not as expected. Either the software in the ACU
does not meet the minimum version required by
the antenna, the software image in the ACU is
corrupted or the upload procedure failed because
of a communication error.
One or more file system partitions are corrupt.
You may have lost your settings and collected
statistics. If restarting the system does not help,
contact your service partner.
The RF calibration is not valid.
An internal power supply voltage is outside its
legal range.