Furuno FV-110GX Operator's Manual page 73

Automatic azimuth calibration with an active satellite profile
You can enable automatic azimuth calibration, even if there is no line of sight to an
azimuth calibration satellite or GX service satellite from the place of installation. To be
able to use this feature you must have made a valid satellite profile and activate it. When
the vessel leaves the harbour and gets line of sight to the GX satellite, the system
automatically finds and tracks the satellite and makes the azimuth calibration. After a
successful azimuth calibration the ACU will automatically disable the Azimuth
calibration (active satellite profile) on the page SERVICE > Calibration.
1. Create a modem profile, see Modem profiles on page 7-13.
2. Create a satellite profile, see Satellite profiles on page 7-12.
3. Click SETTINGS and Activate the satellite profile.
4. Click SERVICE > Calibration.
5. Select Enable in the section Azimuth calibration (active satellite profile). To be able
to use this feature there must be a valid satellite profile and you must activate it in
SETTINGS > Satellite profiles.
6. Click Apply.
7. Switch on the modem.
Figure 5-7: Web interface: SERVICE, Calibration (example)
:
Calibration
5-9