Furuno FV-110GX Operator's Manual page 66

Introduction to the built-in web interface
Figure 5-1: LAN 3 connector used for configuring the FV-110GX
If you want to use another LAN port to access the web interface you must configure it
as described in To configure the LAN network on page 5-23.
3. Open your Internet browser and enter the IP address of the ACU. The default IP
address is http://192.168.0.1.
When the login screen is displayed you have verified that the connection to the FV-
110GX can be established. The web interface is ready for use.
First time login as administrator
For a new installation you must activate local administration and set the admin password.
This is also the case after reset to factory default.
Do as follows:
1. On the ACU keypad, push and hold the left arrow key for 5 seconds.
2. Wait for the very short display of Local administration, followed by the event text:
0807F-0 WARNING Local administration enabled.
This will give you temporary administrator access for 1 hour or until next restart.
3. Open your browser and access the web interface.
4. Enter user name: admin (no password is required).
The DASHBOARD is displayed.
Accessing the ACU with the local administration function
Note
does not change the current administrator password.
5. To enter or change the password select ADMINISTRATION > User login and locate
the section Change Login.
6. If needed, type in the new password (minimum 8 characters) and click Change. No
old password is required.
After the 1 hour window or a restart the administrator password is required.
If you cannot establish a connection there might be problems with the Proxy server
settings of your PC. See Proxy server settings in your browser on page 7-4 for further
information.
5-2
Figure 5-2: Logon screen