Rinsing The Mx Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Installation and initial operation

Rinsing the MX print head

Rinse the system before the initial operation.
With a short push on the button it happen a flush run, the vacuum pump of the
maintenance station runs to suck off the ink rests. The vacuum pump runs after ca. 1
sec. shortly to rinse ink, air and dust from the nozzles, afterwards the vacuum pump runs
ca. 10 sec. to suck off the ink rests completely.
Instruction
Please rinse the MX print head as follows:
Step
1
After rinsing, a test print should be done. If the print result is not satisfactory,
repeat steps bleeding and rinsing.
Material damage due to ink leavings!
Rinsing of the MX-Top print head results increased ink
consumption and can lead to undesirable contamination
of the environment.
Therefore:
–
Secure the environment against leaking ink.
–
Afterwards wipe the nozzle plate once with a lint-free
cloth
Procedure
Press the [PURGE] button on the system flange plate.
Seite 91 von 162
72800153 Markoprint XB4JET / XB8JET
GB