Rinsing And Bleeding The Mx Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Faults

Rinsing and bleeding the MX print head

Rinse the system before the initial operation or worsening of the print quality
Fehler! Verweisquelle konnte nicht gefunden werden., page Fehler! Textmarke nicht
definiert..
Instruction
Please rinse the MX print head as follows:
Step
1
With a short push on the button it happen a flush run, the vacuum pump of the
maintenance station runs to suck off the ink rests. The vacuum pump runs after ca. 1
sec. shortly to rinse ink, air and dust from the nozzles, afterwards the vacuum pump runs
ca. 10 sec. to suck off the ink rests completely.
If the contamination is too persistent and cannot be removed by the rinsing
procedure, return the unit to our factory for expert cleaning. Please note that this
constitutes a service which entails costs, even during the warranty period.
If the normal unit environment is constantly subject to large dust accumulation,
we recommend having the unit cleaned at the factory in regular intervals of once
or twice per year.
Material damage due to ink leavings!
Rinsing of the MX-Top print head results increased ink
consumption and can lead to undesirable contamination
of the environment.
Therefore:
–
Secure the environment against leaking ink.
–
Afterwards wipe the nozzle plate once with a lint-free

cloth
gefunden werden., page Fehler! Textmarke nicht
definiert.
Procedure
Press the [PURGE] button on the system flange plate.
Seite 109 von 162
72800153 Markoprint XB4JET / XB8JET
Chapter Fehler! Verweisquelle konnte nicht

Chapter
GB