Table Of Faults; Controller; Hp Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Faults

Table of faults

Controller

Disorder Possible cause
Controller No power supply
does not
start
No screen No signal from the system
display
Print head No start pulse
does not
produce a
Print parameter incorrect
print
image
Fault in the electronics of
the controller or the print
head
Faulty rotary encoder or
incorrect
settings

HP print head

Disorder Possible cause
The print No start pulse
head does
not print
Print parameter incorrect
at all
Fault in the electronics of the
print head
Faulty rotary encoder or
incorrect
settings
Bad and The distance between print
fuzzy print head and product is too big
image
Low intensity
Empty ink cartridge
Blocked nozzles
Troubleshooting
Check power supply
Start the system
Check
connection cable
Check print parameter,
adjust if necessary
Send controller or print
head in for repairs
Check rotary encoder
rotary encoder and encoder settings
Troubleshooting
Check
connection
Check print parameter,
adjust if necessary
Send print head in for
repair
Check rotary encoder
rotary encoder and encoder settings
Reduce distance to 0 -3
mm
Increase intensity
Change ink cartridge
Spitting and wipe the
nozzle
necessary
Seite 102 von 162
72800153 Markoprint XB4JET / XB8JET
Recovered by
Electrician
Instructed
person
photocell and Electrician
Instructed
person
Manufacturer
Instructed
person
Recovered by
photo sensor Electrician
Instructed
person
Manufacturer
Instructed
person
Qualified
person
Instructed
person
Instructed
person
Instructed
plate if person
GB