Faults; Safety - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Faults

Faults
The following chapter describes possible causes of malfunctions and how to remedy
these.
In case of frequent faults, reduce the service intervals depending on the actual work
load.
Please contact your local distributor with regard to faults that cannot be remedied
with the information provided below.

Safety

Staff

The fault remediation work described here, unless specified otherwise, can be
performed by the operator.

Some tasks may only be performed by specially trained specialised staff or
exclusively by the manufacturer; this is specifically pointed out in the description
of the individual faults.

Work on the electrical system may only be performed by electricians.
Electrical system
DANGER!
Danger to life through electric shock!
Danger to life if live components are touched. Electrical components that
are switched on may execute uncontrolled movements and cause severe
injury.
Therefore:
–
Improper fault remediation
WARNING!
Risk of injury by improper fault remediation!
Improper fault remediation may cause severe injury to persons, or material
damage.
Therefore:
–
– Keep the working area clean and tidy! Loosely stacked or scattered
Before starting any work, switch off the power supply and pull the
mains plug.
Ensure adequate working space before starting any work.
components and tools are potential causes of accidents.
Seite 101 von 162
72800153 Markoprint XB4JET / XB8JET
GB