Installation; Controller Installation - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Installation and initial operation

Installation

Controller installation

IMPORTANT: To prevent faults due to potential differences, an electro-conductive
connection between control unit and conveyor belt must be established.
CAUTION!
Material damage due to improper controller installation!
With the controller switched on, a defect may occur in the system
electronics.
Therefore:
– Only install the controller if this is switched off.
– Network cables only connect or disconnect if the power supply is dead
When choosing the installation location the following conditions apply:

Consider the generally accepted ergonomic criteria in accordance with workplace
ordinances as well as country-specific legislation.

The installation location must be a dry and dust-free room, ideally with an
ambient temperature of approx. 18...25 °C.

The installation location may not be subject to fast temperature fluctuations
(condensation!).

Do not set up the controller directly next to or above hot surfaces, since this will
affect cooling of the controller.

If the controller is operated on a tripod (accessory), the stability of the tripod on
an even foundation must be ensured.

The controller may not be exposed to flammable, explosive, corrosive gases or
chemical vapours.

The controller may not be installed in the vicinity of high voltage equipment or
power supplies.

The controller may not be subjected to direct vibrations or shocks.

Keep controller away from oil or water.

The controller may not be exposed to strong magnetic or electric fields.
voltage.
Seite 66 von 162
72800153 Markoprint XB4JET / XB8JET
GB