Rinsing And Bleeding The Hp Ink Cartridge With The Ink Activator - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Faults

Rinsing and bleeding the HP ink cartridge with the ink activator


Applied by instructed person.

Apply if, even after wiping the nozzle plate, the print quality does not improve.
Ink cartridges exposed for an extended period may dry up to such an extent that simple
cleaning by wiping is inadequate.
Open ink cartridges subjected to severe shock or shaking may result in air entering the
nozzles. These results in increased nozzle failures during printing or the ink cartridges
stop printing altogether.
In this case, the cartridge nozzles can be rinsed with the ink activator. The ink activator
consists of a holder and an injection.
Requirements

Ink-Activator

Injection
Instruction
Please de-aerate the ink cartridge as follows:
Step
1
2
4
Material damage due to ink leavings!
Please secure the environment against ink leavings by
removing the cartridge or take off the injection.
Therefore:
–
Absorb the excess ink with an absorbent cloth.
Procedure
Insert the ink cartridge in the ink activator holder as shown in the figure.
Press the ink cartridge in the direction of the arrow until the cartridge is firmly
seated in the holder.
Insert the injection in the opening of the holder.
Seite 106 von 162
72800153 Markoprint XB4JET / XB8JET
Fig. 0-2: Inserting ink cartridge in den Ink-Activator
GB