Installation Of The Xr Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Installation and initial operation

Installation of the XR print head

Required Resources

Setscrew wrench (Allen key
Instruction
Please install the print system as follows:
Step
1
2
3
Material damage due to improper print system installation!
With the print system switched on, a defect may occur in the
system electronics.
Therefore:
–
Only install the system when it is switched off.
–
Network cables only connect or disconnect if the power
supply is dead voltage.
Possible material damages!
Product mounting rails prepared by the customer protect the
system unit from vibrations and damage while the product is
passing the system unit.
®
)
Procedure
Attach mounting brackets to the production line.
Put the system unit on the mounting bracket.
Set the distance between the print head and the product surface. A distance
of 0 to 3 mm is optimal (see Fig. 0-1).
For top mounting the level must be set correct (see chapter XAAR –
print head module XR
Install the ink system horizontal and the nozzle plate parallel to the product.
Seite 84 von 162
72800153 Markoprint XB4JET / XB8JET
GB