Mx Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Faults

MX print head

Disorder Possible cause
Fine gaps in Paper dust in the nozzle
the print orifices
image
followed by
satellite
drops
Weak and Distance
blurred print head and object too large -
reduce distance to 3-5 mm
Thick white Air behind nozzle plate
stripes
within the
printed text
The print Head voltage failure / the
head does print head is not being
not print at heated
all
When printing is initiated,
the head generates the
typical,
noise, but no print appears
No start pulse
Start signal too early or
late, relative to the print
object
Failure in the electronics of
the print head or on the
printed circuit board in the
control box
Ink Incorrect level setting when
escaping using a TOP head
from head
Print is too Check used and loaded
small / too fonts .
large
Jagged type Incorrect print speed setting
face
between print
slightly chirping
Seite 104 von 162
72800153 Markoprint XB4JET / XB8JET
Troubleshooting
Run a purging cycle and
carefully wipe the print
head clean. If this is
unsuccessful, send the
print head in
cleaning
Control unit configured
incorrectly in menu
Settings - System
configuration - Head
driver
Carry out purging
process and wipe
carefully
Check cable
electronic board
connections
Air has entered all ink
channels. Carry out a
purging process
Check photo sensor
connection (LED pulse)
Adjust delay in the print
parameter menu
Send print head in for
repair
No horizontal installation
Air in system - remove
air from tubes/head
All fonts used in the text
must be loaded in the
system – IDESIGN Font
Manager
Check speed setting
(intensity setting
rotary encoder)
Recovered by
Electrician
for
Qualified
person
Instructed
person
and Electrician
Instructed
person
Electrician
Instructed
person
Manufacturer
Instructed
person
Instructed
person
Instructed
on person
GB