Bleed The Mx Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Installation and initial operation

Bleed the MX print head

Bleed the system before the initial operation.
If the PURGE button will be pressed more than 20 seconds, the vacuum pump runs
continuously to de-aerate the print head. Therefore the nozzle plate should be closed
with the head clamp to rinse the ink in a circulation.
The pump stops pumping after 30 sec. automatically.
Instruction
Please bleed the MX print head as follows:
Step
1
2
3
Material damage due to ink leavings!
It can come to undesirable contamination of the
environment by squirting ink during the purging of the MX
print head.
Procedure
Switch the system on.
Put the locking clamp on the nozzle plate.
Press the [PURGE]-button and hold them pressed for ca. 30 seconds.
ATTENTION, ink may leak out of the nozzle plate of the print head.
Seite 89 von 162
72800153 Markoprint XB4JET / XB8JET
Fig. 36: Switch the system on
Fig. 37: Put the locking clamp on
GB