Disassembly Of Amx Print Head - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Disassembly

Disassembly may only be performed by specially trained specialized staff.

Work on the electrical system may only be performed by electricians.
Disassembly of a MX print head
Instruction
Please disassemble the MX print head as follows:
Step
1
2
3
4
5
6
7
8
To prevent damage during transportation, choose a box with adequate padding.
Leave a gap of at least 5cm between unit and box for filling with absorbent and
impact-absorbing filling.
Please do not pack unit in plastic bag.
Because any escaped ink cannot be soaked up, it spreads over the whole unit
causing damage.
The resulting damage and cleaning overhead unnecessarily increase repair costs.
For best possible transportation, original packaging is available from Weber
Marking Systems for this system.
Material damage due to incorrect disposal!
Electronic components are destroyed if allowed to come
into contact with escaping ink.
Therefore:
–
Close the ink systems before disposal carefully.
Procedure
Switch off the control system.
Isolate maintenance station or main adaptor from the print head.
Close the print head with the cleaned locking clamp.
Remove the ink bottle.
Check whether the red sealing ring (o-ring) is present.
Place the red sealing ring into the opening of the ink container and close it
with the screw cap.
Close ventilation opening with the plastic cap.
Disassemble the system and pack it carefully.
Seite 114 von 162
72800153 Markoprint XB4JET / XB8JET
GB