Smartcard Functions - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Assembly and function 72800153 Markoprint XB4JET / XB8JET

SmartCard Functions

The SmartCard functions are supported by software version 2.016 and higher.
Automatic storage of the ink filling level in 1% steps. The correct ink level of a cartridge is always
detected, even by changing the cartridges. No more missing prints by interchanged cartridges.
Automatic detection of the ink type and automatic setting of the optimal ink paramaters. Ink
volume, drop size, nozzle voltage and firing time are stored on the SmartCard chip.
The current ink type is displayed for control and prevention of wrong cartridges.
Exact ink consumption calculation. The usable number of drops is calculated by the ink weight
(g), specific weight (g/ml) and drop size (in pl). The values are read out of the chip, depending on
the ink type.
Warning message with expired shelf life - date of filling and shelf life are stored on the SmartCard
chip
Warning message if cartridge is open for too long (installed life) - date of first insertion and
maximum operating time are stored on the SmartCard chip.
iDesign displays the ink part number for easy reordering.
Following data are stored on the SmartCard chip for checking claims:
Date of the first cartrigde insertion, serial number of the controller, firmware version of the
controller
Date of the last cartridge insertion, serial number of the controller, firmware version of the
controller
Number how many times the cartridge was used.
The ink type can not set manually by using SmartCard cartridges.
The ink level is set automatically and can not be reset.
Seite 44 von 162 GB