Lx Print Head Installation - Weber Markoprint XB4JET Manual For Installation, Operation And Maintenance

Installation and initial operation

LX print head installation

To achieve a clean and sharp printing result, the distance between the product to be
printed and the nozzle plate of the print head is important. The optimal distance is 0 to
8 mm. A higher distance impairs the print result, especially if the conveyor belt runs at
high speeds.
The distance from the print head to the product must be as short as possible, with high
print speed mainly. The distance between print head and product can be 10 mm if the
print speed is less than 20 m/min.
Installation must be performed by specialised staff:
1. Attach mounting brackets to the production line.
2. Attach the mounting rail of the print head to the clamp of the mounting bracket.
3. Set the distance between the print head and the product surface. A distance of 0 to 8 mm
is optimal
Lateral product guides fitted on site protect the print head against vibrations and
damage whilst the product passes the print head. (Fig. 30)
4. Connect the print head cable to the connector of the print head and screw tight.
72800153 Markoprint XB4JET / XB8JET
Seite 77 von 162
A
0-8mm
Product leadership
Fig. 30: Print head installation
GB