Replacing The System Backplane In An Air-Cooled 8335-Gtb - IBM Power System S822LC Manual

Figure 118. Lifting out the system backplane
15. Place the system backplane on the ESD mat.

Replacing the system backplane in an air-cooled 8335-GTB

Learn how to replace the system backplane in an air-cooled IBM Power System S822LC (8335-GTB)
system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Remove the replacement system backplane from the static-protective package and place it on an ESD
mat.
3. Using the blue lift points (A), lower the system backplane (B) into the system, sliding it to the back
of the system. Ensure that the connectors align and pass through the rear of the system.
100
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)