Replacing The Power Switch And Cable In The 8335-Gtb System - IBM Power System S822LC Manual

Figure 107. Removing front USB cable from power switch
11. Place the front USB cable and the power switch on the table.

Replacing the power switch and cable in the 8335-GTB system

Learn how to replace the power switch and cable in the IBM Power System S822LC (8335-GTB) system.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap attached. If not, attach it now.
2. Find the replacement power switch and cable and remove it from the protective plastic envelope.
3. Connect the front USB cable to the power switch. Push in the retaining latches (A) so that the USB
port locks into the power switch. See Figure 108.
Figure 108. Attaching the front USB cable to the power switch
4. Insert the power switch and cables into the system. Be careful to route the cables through to the
system backplane as shown in Figure 109 on page 91.
90
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)