IBM Power System S822LC Manual page 99
Hide thumbs
Also See for Power System S822LC:
- Servicing (146 pages) ,
- Installing the system and ordered parts (140 pages) ,
- Technical overview and introduction (80 pages)
Table of Contents
Advertisement
Figure 98. Location of the power risers
4. Remove the power riser.
a. If applicable, disconnect the fan power cable from the power riser (A) in Figure 99 on page 84, by
pressing the latch release lever with your thumb.
Note: The latch release on the connector must be depressed before you unplug the cable. Failure
to do so might damage the cable and the connector.
b. Pull out the power riser from the slot by holding the blue tab. See (B) in Figure 99 on page 84.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
83
Advertisement
Table of Contents
