IBM Power System S822LC Manual page 123

Figure 125. Removing dust and debris from the system processor module area
11. On the new system backplane, remove the socket cover from a system processor socket.
12. Prepare the system processor module for removal.
a. Using the supplied removal tool (part number 01AF101), align the beveled corner (A) of the tool
over the beveled corner of the system processor module as shown in Figure 126 on page 108.
b. Lower the tool over the system processor module by ensuring the two guide pins (C) are inserted
into the alignment holes (B) on each side of the tool.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
107