IBM Power System S822LC Manual page 185

8. Install a new TIM pad:
a. Use the supplied scraper to remove the old TIM from the cold plate.
b. Open the TIM packaging and carefully remove the TIM, holding it by the edges of the carrier
strip and holding it away from the shipping container.
c. Remove the protective film from the clear carrier strip by using the supplied tweezers.
Note: The TIM must remain flat. Small wrinkles are acceptable, but folds are not acceptable.
d. Using the tweezers, remove the TIM from the carrier strip and center it onto the system
processor module. The side with the red stripe must be facing up. Align the beveled edges of the
TIM and the system processor module (A) as shown in Figure 194.
Figure 194. Installing the TIM onto the processor lid
9. Install the cold plate.
a. Unhook the cold plate (A) from the service hook (B) and carefully align the cold plate onto the
system processor module as shown in Figure 195 on page 170.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
169