IBM Power System S822LC Manual page 132

Figure 135. Reusing the undamaged silver-colored TIM and heat sink
Continue with step 21 on page 119.
19. Use this step to install a new gray-colored TIM and reuse the existing heat sink.
a. Open the TIM packaging and carefully remove the TIM, holding it by the edges of the carrier
strip and holding it away from the shipping container.
b. Remove the protective film from the clear carrier strip by using the supplied tweezers.
Note: The TIM must remain flat. Small wrinkles are acceptable, but folds are not acceptable.
c. Using the tweezers, remove the TIM from the carrier strip and center it onto the system processor
module. The gray-colored TIM has no preferred up side. The gray-colored TIM can be placed on
the processor and centered as shown in Figure 136 on page 117.
116
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)