IBM Power System S822LC Manual page 104

Figure 103. Removing the front USB cable and the power switch and cable from the system backplane and the disk
drive and fan card
6. Pressing the latch release on the connector, disconnect the power switch and cable (B) from the
system backplane. See Figure 103.
7. Remove the rack installation support from the side of the system. See Figure 104.
Figure 104. Removing the rack installation support
8. Remove the top and side screws from the power switch. See Figure 105 on page 89.
88
Power Systems: Servicing the IBM Power System S822LC (8335-GTB)