IBM Power System S822LC Manual page 39

Figure 29. Removing holder from carrier
b. Slide one cold plate pin into the holder as shown (A) in Figure 30. Push the pin into the slot only
as far as is needed.
Figure 30. Inserting the cold plate pins into the holder
c. Pivot the cold plate to slide the other pin into the holder as shown in (B) in Figure 30. Push the
pin into the slot only as far as is needed.
d. Pinch the holder at the sides (B) as shown in Figure 31 on page 24 and replace it onto the carrier.
Removing and replacing parts in the IBM Power System S822LC (8335-GTB)
23