Q172Dlx Servo External Signals Interface Module - Mitsubishi Electric Melsec-Q172DCPU User Manual

2 SYSTEM CONFIGURATION

2.5.4 Q172DLX Servo external signals interface module

Q172DLX receives external signals (servo external signals) required for positioning
control.
(1) Q172DLX name of parts
5)
6)
4)
No. Name
1) Module fixing hook
2) Input indicator LED
3) CTRL connector
4) Module mounting lever
5) Module fixing screw hole
6) Module fixing projection
7) Serial number display
POINT
Input indicator LED of the proximity dog/speed-position switching signal (DOG/
CHANGE) turns ON at the following conditions.
• Q172DLX is set on the system setting of MT Developer2.
• The proximity dog/speed-position switching signal (DOG/CHANGE) is input.
Hook used to fix the module to the base unit.
(Single-motion installation)
Display the servo external input status from the external
equipment.
LED
Display for servo external signal input status of
0 to 1F
each axis.
The proximity dog/speed-position switching signal (DOG/
CHANGE) does not turn ON without setting Q172DLX in the
system setting.
The servo external signal input connector of each axis.
Used to install the module to the base unit.
Hole for the screw used to fix to the base unit.
(M312 screw : Purchase from the other supplier)
Projection used to fix to the base unit.
Display the serial number described on the rating plate.
2 - 58
Q172DLX
CTRL
Q172DLX
Application
Details
1)
2)
3)
7)