Mitsubishi Electric Melsec-Q172DCPU User Manual page 167

4 INSTALLATION AND WIRING
POINTS
(9) Migrating plasticizer is used for vinyl tape. Keep the MR-J3BUS M, and
MR-J3BUS M-A cables away from vinyl tape because the optical
characteristic may be affected.
SSCNET cable
MR-J3BUS M
MR-J3BUS M-A
MR-J3BUS M-B
: Normally, cable is not affected by plasticizer.
: Phthalate ester plasticizer such as DBP and DOP may affect optical
characteristic of cable.
Generally, soft polyvinyl chloride (PVC), polyethylene resin (PE) and fluorine
resin contain non-migrating plasticizer and they do not affect the optical
characteristic of SSCNET cable. However, some wire sheaths and cable
ties, which contain migrating plasticizer (phthalate ester), may affect
MR-J3BUS M and MR-J3BUS M-A cables (made of plastic). In addition,
MR-J3BUS M-B cable (made of quartz glass) is not affected by plasticizer.
(10) If the adhesion of solvent and oil to the cord part of SSCNET cable may
lower the optical characteristic and machine characteristic. If it is used such
an environment, be sure to do the protection measures to the cord part.
(11) When keeping the Motion CPU or servo amplifier, be sure to put on a cap to
connector part so that a dirt should not adhere to the end of SSCNET
connector.
(12) SSCNET connector to connect the SSCNET cable is put a cap to protect
light device inside connector from dust. For this reason, do not remove a cap
until just before connecting SSCNET cable. Then, when removing
SSCNET cable, make sure to put a cap.
(13) Keep the cap and the tube for protecting light cord end of SSCNET cable in
a plastic bag with a zipper of SSCNET cable to prevent them from
becoming dirty.
(14) When exchanging the Motion controller or servo amplifier, make sure to put a
cap on SSCNET connector. When asking repair of Motion controller or
servo amplifier for some troubles, make also sure to put a cap on SSCNET
connector. When the connector is not put a cap, the light device may be
damaged at the transit. In this case, exchange and repair of light device is
required.
Optical cord
Cord
4 - 16
Cable
Cable