Table of Contents
Advertisement
MAP Control Center
The Seismic Test is the same as the Walk Test and uses the same screen, except it only tests
seismic detectors. Seismic detectors equipped with a test transmitter are tested
automatically. Points that do not have a test transmitter must be triggered manually. The
Seismic Test can only be carried out if all areas are disarmed.
Print Walk Test
Figure 2.88 Print Walk Test screen
See also
–
–
2.8.6
Motion Detector Test
On the Service menu (Figure 2.64 Service Menu – screen 2, page 43), press Motion Detector
Test. The Motion Detector Test Select screen (Figure 2.89 Motion Detector Test Select screen,
page 55) appears with a green check mark or a red "X" symbol on the Motion Test All Areas
button, indicating:
–
–
Figure 2.89 Motion Detector Test Select screen
To change the symbol on the Motion Test All Areas button, press the button.
Bosch Sicherheitssysteme, GmbH
Walk Test, page 54
Walk Test, page 55
Test mode is On (
), or
Test mode is off (
).
User Manual
Operation | en
55
2014.11 | 06 | F.01U.168.328
Advertisement
Table of Contents
