Change Passcode - Bosch MAP Control Center IUI-MAP0001-2 User Manual

MAP Control Center
If you wish to add or change a Smartkey token number, press the Enter Smartkey Token
button. The Enter Smartkey Token Number keypad screen (Figure 2.21 Enter Smartkey Token
Number keypad screen, page 22) opens. Refer to Section Add Smartkey User, page 21 for
instructions on entering (or editing) the Smartkey token's hexadecimal number on the keypad
screen.
Edit Control Center User
From the Edit User - User ID screen (Figure 2.36 Edit User – User ID screen, page 30), press
Edit Control Center User. The Edit Control Center User screen (Figure 2.38 Edit Control
Center User screen, page 31) opens. Refer to Section Add Control Center User, page 23 for
instructions on adding or editing information about the control center user.
Figure 2.38 Edit Control Center User screen
2.5.4 Change Passcode
To change a logged-in user's passcode, press Change Passcode. The Change Passcode screen
(Figure 2.39 Change Passcode screen, page 31) opens. Using the on-screen numeric keypad,
enter the new passcode in the Enter New Passcode field, then verify the new passcode by
entering it again in the Verify New Passcode field.
Figure 2.39 Change Passcode screen
Bosch Sicherheitssysteme, GmbH User Manual
Operation | en 31
2014.11 | 06 | F.01U.168.328